Post by Ron Kulas on Oct 18, 2008 20:22:41 GMT -6
This Quiver is for the bow I built.
I made a pattern from a piece of padding from when I installed hardwood floors in my dinning room. It is about as thick as the leather I am using but a bit more flexible. It makes a good prototype material.
My biggest concern with having such a big opening in the side of the quiver is that, over time, as the leather softens, it will fold or collapse. I will reinforce the quiver to prevent that from happening.
I am making the quiver out of 8 Oz. tooling leather.
In order to stiffen the sides of the quiver, I stitched long strips of leather to the inside of the quiver.
I left one end open so I could insert 3/32 dia. music wire the entire length of the quiver.
the next step is to at a bit if stiffness and decoration to the opening.
I stitched this piece of 5 Oz. leather to the quiver while flat (before shaping.
The next step is to shape the quiver into it tubular shape. I wetted the leather to allow me to shape the quiver and then used a blow dryer to save a bit of time drying it off. I then marked an overlap and used rubber cement to join the to ends so that I could punch the stitching holes.
With the bottom stitched, I joined both sides of the quiver opening.
Then I cut a slot for the shoulder strap.
Next, I added a piece to the bottom of the quiver that I could attach the other end of the shoulder strap to.
And then gave it a bit of decoration and some stitching holes.
Stitching the already rolled tube proved to be a real pain.
For the bottom of the quiver, I used a piece of 3/4 inch thick pine.
And then added a layer of foam to reduce the noise.
The bottom is held in place with decorative nails.
I do not have a large enough piece of leather to make a continuous shoulder strap so I have to join a few strips together that I cut out of one of my bigger pieces.
I made a pattern from a piece of padding from when I installed hardwood floors in my dinning room. It is about as thick as the leather I am using but a bit more flexible. It makes a good prototype material.
My biggest concern with having such a big opening in the side of the quiver is that, over time, as the leather softens, it will fold or collapse. I will reinforce the quiver to prevent that from happening.
I am making the quiver out of 8 Oz. tooling leather.
In order to stiffen the sides of the quiver, I stitched long strips of leather to the inside of the quiver.
I left one end open so I could insert 3/32 dia. music wire the entire length of the quiver.
the next step is to at a bit if stiffness and decoration to the opening.
I stitched this piece of 5 Oz. leather to the quiver while flat (before shaping.
The next step is to shape the quiver into it tubular shape. I wetted the leather to allow me to shape the quiver and then used a blow dryer to save a bit of time drying it off. I then marked an overlap and used rubber cement to join the to ends so that I could punch the stitching holes.
With the bottom stitched, I joined both sides of the quiver opening.
Then I cut a slot for the shoulder strap.
Next, I added a piece to the bottom of the quiver that I could attach the other end of the shoulder strap to.
And then gave it a bit of decoration and some stitching holes.
Stitching the already rolled tube proved to be a real pain.
For the bottom of the quiver, I used a piece of 3/4 inch thick pine.
And then added a layer of foam to reduce the noise.
The bottom is held in place with decorative nails.
I do not have a large enough piece of leather to make a continuous shoulder strap so I have to join a few strips together that I cut out of one of my bigger pieces.
